1
2 3 4
5 6 7
8 9 10
Printable
PDF of this presentation
|
Slide 2 The sample geometry is a circular cylinder with a reduced diameter gauge section as seen at the bottom of this slide. At the ends there is a 25.4mm diameter grip region for holding the samples in our hydraulic collet grips. Some of the samples are hollow cylinders and some are solid. All of the samples start as solid cylinders a few mm larger than the final grip region diameter of 25.4mm. The cylinders are first cut down to 25.4mm (one inch) outer diameter. For the hollow samples, a hole is then drilled. This hole is then reamed to the precise inner diameter. Once the hole is cut, the cylinder is machined to produce the reduced diameter gauge section and fillet. |
|
Chalk
Talks Virtual
Tests Test Data Lab Manual |